Unit, Poly Bag, Case, and inner car

Unit, Poly Bag, Case, and inner carton (If present) dimensions are obtained by the supplier after development product packaging has been agreed on and a suitable carton has been sourced. All measurements are due to PPI at the time that Product Development approves the structure of both the product and packaging. Dimensions must be sent to PPI no later than the time that the ‘Golden Samples’ are made. The cartons to be measured must be assembled and packed as to best simulate normal packaging operations. Dimensions are to be sent to PPI Master Data.

結果 (繁體中文) 1:

單元，塑料袋，錶殼，和內箱（如果存在的話）的尺寸是由開發產品的包裝後的供應商獲得的已同意和合適的紙箱已來源。所有測量到PPI是由於在產品開發批准產品和包裝兩者的結構的時間。尺寸必須大於“黃金樣品”是由時間不遲發送到PPI。要測量的紙箱必須組裝並包裝，以最好的模擬正常包裝操作。尺寸將被發送到PPI主數據。

結果 (繁體中文) 2:

在商定開發產品包裝並採購合適的紙箱後，供應商可獲得單位、Poly Bag、箱和內紙箱（如果存在）尺寸。在產品開發批准產品和包裝結構時，所有測量均由 PPI 進行。尺寸必須不遲于"黃金樣本"的製作時間發送到 PPI。要測量的紙箱必須組裝和包裝，以最好地類比正常的包裝操作。維度將發送到 PPI 主資料。

結果 (繁體中文) 3:

組織、聚乙烯袋、箱子和內紙箱（如有）尺寸由供應商在商定開發產品包裝並採購合適的紙箱後獲得。所有量測都是由於產品開發準予產品和包裝結構時的PPI。尺寸必須在製作“黃金樣品”之前發送給PPI。要量測的紙箱必須組裝和包裝，以便最好地類比正常的包裝操作。尺寸將發送至PPI主數據。